Removable Media Power Cable
Routed Through the Cable Clip
on the Back of the DVD Drive.
5. Connect the SCSI cable to the rear of the drive.
6. Install the left and right media rails and clips to the drive.
7. Fold the cables out of the way and slide the drive into the chassis. The drive easily slides
into the chassis; however, a slow firm pressure is needed for proper seating. The front locking
tab will latch to secure the drive in the chassis.
Removing and Replacing a Slimline DVD Drive
The Slimline DVD drive is located in the front of the chassis. This CRU is hot-pluggable.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to
follow ESD safety precautions could result in damage to the server.
Figure 6-23 DVD Drive Location
To Next Page
Loading...
