The 60A IEC PDU has four 16A circuit breakers and is constructed for International use. Each
of the four circuit breakers has two IEC-320 C19 outlets providing a total of eight IEC-320 C19
outlets.
Each PDU is 3U high and is rack-mounted in the server cabinet.
Documentation for installation will accompany the PDU. The documentation can also be found
at the external Rack Solutions Web site at:
http://www.hp.com/racksolutions
This PDU might be referred to as a Relocatable Power Tap outside HP.
The PDU installation kit contains the following:
• PDU with cord and plug
• Mounting hardware
• Installation instructions
Installing Additional Cards and Storage
This section provides information on additional products ordered after installation and any
dependencies for these add-on products.
The following options may be installed in the server.
• Additional hard disk drive storage
• Removable media device storage
• PCI and PCI-X I/O cards
Installing Additional Hard Disk Drives
The disk drives are located in the front of the chassis (Figure 3-17). The hard disk drives are
hot-plug drives.
A list of replacement disk drives for the server is in Appendix A of the HP Service Guide. The
list contains both removable media disk drives and hard disk drives.
58 Installing the Server
To Next Page
Loading...
