Figure 3-31 The lc Command Screen
MP:CM> lc
This command modifies the LAN parameters.
Current configuration of MP customer LAN interface
MAC address : 00:12:79:b4:03:1c
IP address : 15.11.134.222 0x0f0b86de
Hostname : metro-s
Subnet mask : 255.255.248.0 0xfffff800
Gateway : 15.11.128.1 0x0f0b8001
Status : UP and RUNNING
Link : Connected 100Mb Half Duplex
Do you want to modify the configuration for the MP LAN (Y/[N]) q
NOTE: The value in the IP address field has been set at the factory. Obtain the LAN IP
address from the customer.
3. At the prompt, Do you want to modify the configuration for the MP LAN?,
enter Y.
The current IP address is shown; and the following prompt displays: Do you want to
modify it? (Y/[N])
4. Enter Y.
5. Enter the new IP address.
The customer must provide this address for network interface 0.
6. Confirm the new address.
7. Enter the MP Hostname.
This is the host name for the customer LAN. The name can be as many as 64 characters in
length, and include alphanumeric characters, - (dash), _ (under bar),. (period), or a space.
HP recommends that the name be a derivative of the complex name. For example,
Acme.com_MP.
8. Enter the LAN parameters for the Subnet mask and Gateway address fields.
This information must come from the customer.
When this step is completed, the system will indicate that the parameters have been updated
and return to the MP Command Menu prompt (MP:CM>)
9. To check the LAN parameters and status, enter the ls command at the MP Command Menu
prompt (MP:CM>).
78 Installing the Server
To Next Page
Loading...
Need help?
General