HP Vectra User Manual

Flexible Disc Controller Subsystem
The flexible disc controller subsystem is responsible for converting
high level software commands into
the control and data signals
used by a flexible disc drive. The flexible disc controller subsystem
can support up
to two flexible disc drives. The flexible drives
supported are the HP45812A 1.2 MB Internal Flexible Disc Drive
and
the HP45811A 360 KB Internal Flexible Disc Drive. The
subsystem controller
is located on the processor board. It
interfaces
to the various drive configurations via a 34-pin
connector.
Jumpers
There are three jumpers on the processor board used to configure
the flexible disc controller subsystem. The jumpers are: EE, Ee, ED;
E3
,
E2
,
E1; and E7
,
E8. The following figure shows the
configurations for these jumpers.
44 Processor Boa rd

HP Vectra Specifications

General

Processor	Intel Pentium
RAM	Up to 128 MB
Storage	HDD (capacity varies by model)
Operating System	Windows 95
Graphics	Integrated
Ports	Serial, Parallel
Expansion Slots	ISA, PCI