HPE FlexFabric 5940 SERIES

102
Use undo qos wred apply to restore the default.
Syntax
qos wred apply [ table-name ]
undo qos wred apply
Default
No WRED table is applied to an interface, and the tail drop mode is used on an interface.
Views
Layer 2/Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
table-name: Specifies a WRED table by its name, a case-sensitive string of 1 to 32 characters. If you
do not specify a WRED table, this command applies the default WRED table to the interface.
Examples
# Apply WRED table table1 to Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wred apply table1
Related commands
display qos wred interface
display qos wred table
qos wred queue table
qos wred queue table
Use qos wred queue table to create a WRED table and enter its view, or enter the view of an
existing WRED table.
Use undo qos wred queue table to delete a WRED table.
Syntax
qos wred queue table table-name
undo qos wred queue table table-name
Default
No WRED tables exist.
Views
System view
Predefined user roles
network-admin
Parameters
table table-name: Specifies a name for the WRED table, a case-sensitive string of 1 to 32
characters.