55
Usage guidelines
A QoS policy applied in control plane view takes effect on all packets to the control plane except the
packets sent from the management interface.
Examples
# Enter the control plane view of slot 3.
<Sysname> system-view
[Sysname] control-plane slot 3
[Sysname-cp-slot3]
display qos policy
Use display qos policy to display QoS policies.
Syntax
display qos policy user-defined [ policy-name [ classifier classifier-name ] ] [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
user-defined: Specifies user-defined QoS policies.
policy-name: Specifies a QoS policy by its name, a case-sensitive string of 1 to 31 characters. If you
do not specify a QoS policy, this command displays all user-defined QoS policies.
classifier classifier-name: Specifies a traffic class by its name, a case-sensitive string of 1 to 31
characters. If you do not specify a traffic class, this command displays all traffic classes.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays the QoS policies for the master device.
Examples
# Display all user-defined QoS policies.
<Sysname> display qos policy user-defined
User-defined QoS policy information:
Policy: 1 (ID 100)
Classifier: 1 (ID 100)
Behavior: 1
Marking:
Remark dscp 3
Committed Access Rate:
CIR 112 (kbps), CBS 7000 (Bytes), EBS 512 (Bytes)
Green action : pass
Yellow action : pass
Red action : discard
Classifier: 2 (ID 101)
Behavior: 2
To Next Page
Loading...
