85
undo qos sp
Default
Byte-count WRR queuing is used on an interface, and queues 0 through 7 have a weight of 1, 2, 3, 4,
5, 9, 13, and 15, respectively.
Views
Layer 2/Layer 3 Ethernet interface view
Predefined user roles
network-admin
Examples
# Enable SP queuing on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos sp
Related commands
display qos queue sp interface
WRR commands
display qos queue wrr interface
Use display qos queue wrr interface to display the WRR queuing configuration of an interface.
Syntax
display qos queue wrr interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the WRR queuing configuration of all interfaces.
Examples
# Display the WRR queuing configuration of Ten-GigabitEthernet 1/0/1.
<Sysname> display qos queue wrr interface ten-gigabitethernet 1/0/1
Interface: Ten-GigabitEthernet1/0/1
Output queue: Weighted Round Robin queuing
Queue ID Queue name Group Byte count
--------------------------------------------------------
0 be 1 1
1 af1 1 1
2 af2 1 1
3 af3 1 1
4 af4 1 1
To Next Page
Loading...
Need help?
General