HPE FlexFabric 5940 SERIES

81
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the rate limit information for all interfaces.
Examples
# Display the rate limit information for all interfaces.
<Sysname> display qos lr interface
Interface: Ten-GigabitEthernet1/0/1
Direction: Inbound
CIR 2000 (kbps), CBS 20000 (Bytes), EBS 0 (Bytes)
Passed : 1000 (Packets) 1000 (Bytes)
Discarded: 1000 (Packets) 1000 (Bytes)
Delayed : 1000 (Packets) 1000 (Bytes)
Active shaping: No
Interface: Ten-GigabitEthernet1/0/2
Direction: Outbound
CIR 50 (kbps), CBS 600 (Bytes), EBS 0 (Bytes)
Passed : 1000 (Packets) 1000 (Bytes)
Discarded: 1000 (Packets) 1000 (Bytes)
Delayed : 1000 (Packets) 1000 (Bytes)
Active shaping: No
Table 31 Command output
Field Description
Interface Interface name, including the interface type and interface number.
Direction Direction to which the rate limit configuration is applied: inbound or outbound.
CIR CIR in kbps.
CBS CBS in bytes.
EBS EBS in bytes.
Passed Number and bytes of packets that have passed.
Delayed Number and bytes of delayed packets.
Active shaping
Indicates whether the rate limit configuration is activated:
• Yes—Activated.
• No—Not activated.
qos lr
Use qos lr to configure rate limiting on an interface or PW.
Use undo qos lr to delete the rate limit configuration.
Syntax
qos lr { inbound | outbound } cir committed-information-rate [ cbs committed-burst-size ]
undo qos lr { inbound | outbound }