88
Use undo qos wrr group sp to remove a queue from the SP group.
Syntax
qos wrr queue-id group sp
undo qos wrr queue-id
Default
All queues on a WRR-enabled interface are in WRR group 1.
Views
Layer 2/Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
queue-id: Specifies a queue by its ID. The value range for this argument is 0 to 7 or keywords
in Table 30.
Usage guidelines
This command is available only on a WRR-enabled interface. Queues in the SP group are scheduled
with SP. The SP group has higher scheduling priority than the WRR groups.
You must use the qos wrr command to enable WRR queuing before you can configure this
command on an interface.
Examples
# Enable WRR queuing on Ten-GigabitEthernet 1/0/1, and assign queue 0 to the SP group.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr weight
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 0 group sp
Related commands
display qos queue wrr interface
qos wrr
WFQ commands
display qos queue wfq interface
Use display qos queue wfq interface to display the WFQ configuration of an interface.
Syntax
display qos queue wfq interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
To Next Page
Loading...
