EasyManuals Logo

HPE FlexFabric 5940 SERIES Command Reference

HPE FlexFabric 5940 SERIES
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
7
Field Description
This is an IPv4 basic ACL. Description of the ACL.
ACL's step is 5 The rule numbering step is 5.
rule 5 permit source 1.1.1.1 0
Content of rule 5. The rule permits packets sourced from the IP address
1.1.1.1.
rule 5 comment This rule is
used on
Ten-GigabitEthernet1/0/1.
Comment of rule 5.
display packet-filter
Use display packet-filter to display ACL application information for packet filtering.
Syntax
display packet-filter { interface [ interface-type interface-number ] [ inbound | outbound ] |
interface vlan-interface vlan-interface-number [ inbound | outbound ] [ slot slot-number ] }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface [ interface-type interface-number ]: Specifies an interface by its type and number. VLAN
interfaces are not supported. If you do not specify an interface, this command displays ACL
application information for packet filtering on all interfaces except VLAN interfaces.
interface vlan-interface vlan-interface-number: Specifies a VLAN interface by its number.
vlan [ vlan-id ]: Specifies a VLAN by its ID. If you do not specify a VLAN, this command displays ACL
application information for packet filtering in all VLANs.
inbound: Specifies the inbound direction.
outbound: Specifies the outbound direction.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays ACL application information for packet filtering for the master device.
Usage guidelines
If neither the inbound keyword nor the outbound keyword is specified, this command displays ACL
application information for packet filtering in both directions.
Examples
# Display ACL application information for inbound packet filtering on interface Ten-GigabitEthernet
1/0/1.
<Sysname> display packet-filter interface ten-gigabitethernet 1/0/1 inbound
Interface: Ten-GigabitEthernet1/0/1
Inbound policy:
IPv4 ACL 2001
IPv6 ACL 2002 (Failed)
MAC ACL 4003, Hardware-count (Failed)
IPv4 ACL 2004, Hardware-count (Failed)

Table of Contents

Other manuals for HPE FlexFabric 5940 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexFabric 5940 SERIES and is the answer not in the manual?

HPE FlexFabric 5940 SERIES Specifications

General IconGeneral
BrandHPE
ModelFlexFabric 5940 SERIES
CategorySwitch
LanguageEnglish

Related product manuals