69
[Sysname-qospolicy-user1]
Related commands
classifier behavior
qos apply policy
qos apply policy global
qos vlan-policy
qos vlan-policy
Use qos vlan-policy to apply a QoS policy to the specified VLANs.
Use undo qos vlan-policy to remove a QoS policy from the specified VLANs.
Syntax
qos vlan-policy policy-name vlan vlan-id-list { inbound | outbound }
undo qos vlan-policy policy-name vlan vlan-id-list { inbound | outbound }
Default
No QoS policy is applied to a VLAN.
Views
System view
Predefined user roles
network-admin
Parameters
policy-name: Specifies a QoS policy by its name, a case-sensitive string of 1 to 31 characters.
vlan vlan-id-list: Specifies a space-separated list of up to eight VLAN IDs or a VLAN ID range in the
form of vlan-id1 to vlan-id2. The value for vlan-id2 must be greater than or equal to the value for
vlan-id1. The value range for the vlan-id argument is 1 to 4094.
inbound: Applies the QoS policy to incoming packets.
outbound: Applies the QoS policy to outgoing packets.
Examples
# Apply QoS policy test to the incoming traffic of VLAN 200, VLAN 300, VLAN 400, and VLAN 500.
<Sysname> system-view
[Sysname] qos vlan-policy test vlan 200 300 400 500 inbound
reset qos policy control-plane
Use reset qos policy control-plane to clear the statistics of the QoS policy applied to a control
plane.
Syntax
reset qos policy control-plane slot slot-number
Views
User view
Predefined user roles
network-admin
To Next Page
Loading...
