HPE FlexFabric 5940 SERIES

35
QoS policy commands
Traffic class commands
display traffic classifier
Use display traffic classifier to display traffic classes.
Syntax
display traffic classifier user-defined [ classifier-name ] [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
user-defined: Specifies user-defined traffic classes.
classifier-name: Specifies a traffic class by its name, a case-sensitive string of 1 to 31 characters. If
you do not specify a traffic class, this command displays all traffic classes.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays the traffic classes for the master device.
Examples
# Display all user-defined traffic classes.
<Sysname> display traffic classifier user-defined
User-defined classifier information:
Classifier: 1 (ID 100)
Operator: AND
Rule(s) :
If-match acl 2000
Classifier: 2 (ID 101)
Operator: AND
Rule(s) :
If-match protocol ipv6
Classifier: 3 (ID 102)
Operator: AND
Rule(s) :
-none-