91
Examples
# Enable weight-based WFQ on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq weight
# Enable byte-count WFQ on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq byte-count
Related commands
display qos queue wfq interface
qos wfq { byte-count | weight }
Use qos wfq { byte-count | weight } to assign a queue to a WFQ group with a certain scheduling
weight.
Use undo qos wfq to delete the WFQ queuing parameters of a queue on an interface.
Syntax
qos wfq queue-id group 1 { byte-count | weight } schedule-value
undo qos wfq queue-id
Default
All queues on a WFQ-enabled interface are in WFQ group 1 and have a weight of 1.
Views
Layer 2/Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
queue-id: Specifies a queue by its ID. The value range for this argument is 0 to 7 or keywords
in Table 30.
group 1: Specifies the WF
Q group. Only WFQ group 1 is supported in the current software version.
byte-count: Allocates bandwidth to queues in terms of bytes.
weight: Allocates bandwidth to queues based on their weights.
schedule-value: Specifies a scheduling weight for the specified queue in WFQ queuing. The value
range for this argument is 1 to 15.
Usage guidelines
You must use the qos wfq command to enable WFQ before you configure this command.
Examples
# Enable byte-count WFQ on Ten-GigabitEthernet 1/0/1, and specify scheduling weight 10 for queue
0.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq byte-count
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 0 group 1 byte-count 10
To Next Page
Loading...
