48
[Sysname] traffic behavior b1
[Sysname-behavior-b1] remark customer-vlan-id 111
remark dot1p
Use remark dot1p to configure an 802.1p priority marking action or an inner-to-outer tag priority
copying action in a traffic behavior.
Use undo remark dot1p to restore the default.
Syntax
remark [ green | red | yellow ] dot1p dot1p-value
undo remark [ green | red | yellow ] dot1p
remark dot1p customer-dot1p-trust
undo remark dot1p
Default
No 802.1p priority marking action or inner-to-outer tag priority copying action is configured.
Views
Traffic behavior view
Predefined user roles
network-admin
Parameters
green: Specifies green packets.
red: Specifies red packets.
yellow: Specifies yellow packets.
dot1p-value: Specifies the 802.1p priority to be marked for packets, in the range of 0 to 7.
customer-dot1p-trust: Copies the 802.1p priority value in the inner VLAN tag to the outer VLAN
tag.
Usage guidelines
The remark dot1p dot1p-value and remark dot1p customer-dot1p-trust commands override each
other in the same traffic behavior. The remark dot1p customer-dot1p-trust command does not
take effect on single-tagged packets.
If you execute the remark dot1p dot1p-value command multiple times for the same color, the most
recent configuration takes effect.
Examples
# Configure traffic behavior database to mark matching traffic with 802.1p 2.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] remark dot1p 2
# Configure an inner-to-outer tag priority copying action in traffic behavior database.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] remark dot1p customer-dot1p-trust
To Next Page
Loading...
