116
<Sysname> system-view
[Sysname] buffer egress cell total-shared ratio 50
burst-mode enable
Use burst-mode enable to enable the Burst feature.
Use undo burst-mode enable to disable the Burst feature.
Syntax
burst-mode enable
undo burst-mode enable
Default
The Burst feature is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
The Burst feature is especially useful for reducing packet losses under the following circumstances:
• Broadcast or multicast traffic is intensive, resulting in bursts of traffic.
• Traffic enters a device from a high-speed interface and goes out of a low-speed interface.
• Traffic enters a device from multiple same-rate interfaces and goes out of an interface with the
same rate.
The burst-mode enable command cannot be configured together with any other command in this
chapter.
Examples
# Enable the Burst feature.
<Sysname> system-view
[Sysname] burst-mode enable
display buffer
Use display buffer to display buffer size settings.
Syntax
display buffer [ slot slot-number ] [ queue [ queue-id ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
To Next Page
Loading...
