118
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
slot slot-number: Specifies an IRF member device by its member ID (slot number). If you do not
specify an IRF member device, this command displays buffer usage for all IRF member devices.
Examples
# Display buffer usage.
<Sysname> display buffer usage
Egress total-shared cell buffer usage on slot 1 :
Total: 16061 KB
Used: 0 KB
Free: 16061 KB
5sec 1min 5min
------------------------------------------------------------------
Block 1 0% 0% 0%
FGE9/0/1 0% 0% 0%
FGE9/0/2 0% 0% 0%
FGE9/0/3 0% 0% 0%
FGE9/0/4 0% 0% 0%
FGE9/0/5 0% 0% 0%
FGE9/0/6 0% 0% 0%
FGE9/0/7 0% 0% 0%
Table 44 Command output
Field Description
Egress total-shared cell buffer usage
on slot
Usage of cell resources in the shared area on an IRF member
device.
Block
Block where the port resides. The block where the ports on the front
panel of the device reside is fixed to Block 1.
Total Total size of the data buffer.
Used Size of used data buffer.
Free Size of free data buffer.
5sec Percentage of the buffer that the port uses for the last 5 seconds.
1min Percentage of the buffer that the port uses for the last 1 minute.
5min Percentage of the buffer that the port uses for the last 5 minutes.
To Next Page
Loading...
