59
Syntax
display qos policy global [ slot slot-number ] [ inbound | outbound ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
inbound: Displays inbound global QoS policies. An inbound global QoS policy applies to the
incoming traffic globally.
outbound: Displays outbound global QoS policies. An outbound global QoS policy applies to the
outgoing traffic globally.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays global QoS policies for the master device.
Usage guidelines
If you do not specify a direction, this command displays both inbound and outbound global QoS
policies.
Examples
# Display QoS policies applied globally.
<Sysname> display qos policy global
Direction: Inbound
Policy: 1
Classifier: 1
Operator: AND
Rule(s) :
If-match acl 2000
Behavior: 1
Marking:
Remark dscp 3
Committed Access Rate:
CIR 112 (kbps), CBS 7000 (Bytes), EBS 512 (Bytes)
Green action : pass
Yellow action : pass
Red action : discard
Green packets : 0 (Packets) 0 (Bytes)
Yellow packets: 0 (Packets) 0 (Bytes)
Red packets : 0 (Packets) 0 (Bytes)
Classifier: 2
Operator: AND
Rule(s) :
If-match protocol ipv6
Behavior: 2
Accounting enable:
0 (Packets)
Filter enable: Permit
To Next Page
Loading...
