HPE StoreVirtual 3200

• Multisite configurations where the sites reside on different subnets.
• Remote copy destinations that reside on a different subnet from the source.
• Application-managed snapshot configurations where the server requesting snapshots and the
storage array receiving the snapshots reside on different subnets.
To add a static route, see:
Adding static routes
Adding static routes
Procedure
1. Using a web browser on an administrative computer, connect to the SVMC, using the IP address or
hostname previously configured for the system.
2. On the StoreVirtual menu, select Storage Controllers.
3. On the navigation pane, select the storage controller in slot 1, and then select Actions > Edit routing
on the content pane.
4. Add a route by specifying:
• The desired interface
• Destination network IP address
• Destination network subnet mask and gateway (router) IP addresses
NOTE:
The interface must reside on the same subnet as the gateway.
5. Repeat step 2 through step 4 for the storage controller in slot 2.
Adding static routes 73