A lithium battery is an enclosed battery system and will not release any gases
under normal operations. If a battery is improperly treated, for example, burnt,
needle-pricked, squeezed, struck by a lightning, overcharged, or subject to other
adverse conditions that may cause battery thermal runaway, the battery may be
damaged or an abnormal chemical reaction may occur inside the battery, resulting
in electrolyte leakage or production of gases such as CO and H
2
. To prevent
re or
device corrosion, ensure that ammable gas is properly exhausted.
The gas generated by a burning battery may irritate your eyes, skin, and throat.
Take protective measures promptly.
Install batteries in a dry area. Do not install them under areas prone to water
leakage, such as air conditioner vents, ventilation vents, feeder windows of the
equipment room, or water pipes. Ensure that no liquid enters the equipment to
prevent faults or short circuits.
Before installing and commissioning batteries, prepare re extinguishing facilities,
such as re ghting sands and carbon dioxide re extinguishers, according to
construction standards and regulations. Before putting the battery room into
operation, ensure that it is equipped with a
re extinguishing system that
complies with local laws and regulations, has been constructed and commissioned,
and can work in automatic and manual control modes.
Before unpacking batteries, ensure that the packing cases are intact and correctly
placed according to the labels on the packing cases during their storage and
transportation. Do not place a battery upside down or vertically, lay it on one side,
or tilt it. Stack the batteries according to the stacking requirements on the packing
cases. Ensure that the batteries do not fall or get damaged. Otherwise, they will
need to be scrapped.
FusionModule2000-S Smart Modular Data Center
User Manual 1 Safety Information
Issue 07 (2022-09-30) Copyright © Huawei Technologies Co., Ltd. 18
To Next Page
Loading...
Need help?
General