Huawei FusionModule2000-S

Paramete
r
Description Recommended Value
Cold aisle
sensor
Enables or disables a sensor. -
Hot aisle
sensor
Enables or disables a sensor. -
5.2.2.2 (Optional) Setting Teamwork Parameters
Setting Teamwork Parameters
Path: Teamwork > Teamwork Settings
Figure 5-13 Teamwork Settings
Parameter Description
Teamwork group No. Species the planned teamwork group number. This
parameter should be the same for all units in the same
teamwork group.
System address Species the planned unit address. The addresses of
units in the same teamwork group must be unique.
Teamwork function Species whether to enable the teamwork function. Set
this parameter based on onsite heat load distribution.
● Disable: A unit operates independently.
● Enable: A unit operates in team with other units.
Networking mode Species the networking mode for teamwork control.
The networking mode selected on the screen must
match the actual networking mode. Otherwise, the
teamwork function is unavailable. In the smart module
scenario, devices are connected through the ETH
gateway or ECC800-Pro, so the networking mode must
be set to FE network.
FusionModule2000-S Smart Modular Data Center
User Manual 5 Power-On Commissioning
Issue 07 (2022-09-30) Copyright © Huawei Technologies Co., Ltd. 165