Huawei Quidway NetEngine 20 series

Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 5 User Management
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-19
Configuration Roadmap
1. Enter the user interface.
2. Configure the priority of VTY0 as 2.
3. Configure the simple authentication and the disconnect time.
Data Preparation
To complete the configuration, you need the following data:
z
The password of the authentication mode
z
The connection time
Configuration Procedure
<Quidway> system-view
[Quidway] user-interface vty 0
[Quidway-ui-vty0] user privilege level 2
[Quidway-ui-vty0] authentication-mode password
[Quidway-ui-vty0] set authentication password simple huawei
[Quidway-ui-vty0] idle-timeout 30
# Use the display this command to check all configurations.
[Quidway-ui-vty0] display this
#
user-interface con 0
user-interface aux 0
user-interface vty 0
user privilege level 2
set authentication password simple huawei
idle-timeout 30 0
user-interface vty 1 4
#
return
# Use the display current-configuration command to view the system files.
[Quidway] display current-configuration
#
sysname Quidway
#
user-interface con 0
user-interface aux 0
user-interface vty 0
user privilege level 2
set authentication password simple huawei
idle-timeout 30 0
user-interface vty 1 4
#
return
Configuration Files
#
sysname Quidway