8 FTP, TFTP and XModem
Quidway NetEngine20/20E
Configuration Guide - Basic Configurations
8-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 05 (2010-01-30)
z
Before getting the file, confirm the path and the name of the file that are to be sent.
z
For the filename, an absolute path name is required.
z
If the filename is similar to an existing one, the system sends a prompt asking you whether to
overwrite or not.
8.8 Configuration Examples
8.8.1 Example for Configuring the FTP Server
Networking Requirements
As shown in Figure 8-1, the IP address of the FTP server is 172.16.104.110/24.
Log in to the router from the HyperTerminal and then download files from the FTP server.
Figure 8-1 Using FTP to download files
Server
172.16.104.110/24
console cable
Configuration Roadmap
1. Run the HyperTerminal on the PC and log in to the router.
2. Use the correct username and password to log in to the FTP server to download the files
on the memory of the router.
Data Preparation
To complete the configuration, you need the following data:
z
FTP username as quidway and password as huawei on the server
z
The correct path of the original files on the FTP server
z
The destination file name and its position in the router
Configuration Procedure
Step 1 Enable FTP on the FTP server and configure the authentication information of the FTP user.
<Quidway> system-view
[Quidway] sysname server
[Server] ftp server enable
To Next Page
Loading...
Need help?
General
