Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 5 User Management
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-9
z
The auto-execute command command should be used carefully because it may cause
failure of the system configuration through the user-interface.
z
Before configuring this command and saving the configuration, you should make sure that
this configuration can be removed by logging in to the system in other ways such as
logging on the router through the console port..
Do as follows on the router that the user logs in to:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface aux 0
The user interface view is displayed.
Step 3 Run:
auto-execute command command
The auto-executed command is set.
----End
5.2.8 Configuring the Redirection Function
Do as follows on the router that the user logs in to:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface [ ui-type ] first-ui-number [ last-ui-number ]
The user interface view is displayed.
Step 3 Run:
redirect
The Telnet redirection is enabled.
----End
To Next Page
Loading...
Need help?
General
