4 Basic Configuration
Quidway NetEngine20/20E
Configuration Guide - Basic Configurations
4-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 05 (2010-01-30)
super [ level ]
User levels are switched.
An accurate password must be entered when the user is switched from a lower level to a
higher level.
When configuring the switchover of user levels on the router, users can perform HWTACACS
Authentication. For detailed configurations, refer to Quidway NetEngine20/20E Series
RoutersConfiguration Guide - Security.
When the login user of lower levels is switched to the user of higher level through super, the system
automatically sends trap messages records the switchover in the log. When the switched level is lower
than that of the current level, the system only records the switchover in the log.
4.2.8 Locking the User Interface
Do as follows on the router:
Run:
lock
The user interface is locked.
When you leave the operation terminals for the moment, you can lock the user interface in
case unauthorized users operate the interface. You must enter the correct password to unlock
the user interface.
4.2.9 Configuring Command Privilege Levels
Do as follows on the router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
command-privilege level rearrange
The command levels are advanced in batches.
Step 3 Run:
command-privilege level level view view-name command-key
The command level is set.
----End
To Next Page
Loading...
Need help?
General
