Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 8 FTP, TFTP and XModem
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-15
8.7 Configuring XModem
8.7.1 Establishing the Configuration Task
Applicable Environment
Configure XModem to transfer files through serial interfaces.
Pre-configuration Tasks
Before configuring XModem, complete the following tasks:
z
Powering on the router
z
Connecting the router and the PC through an AUX port or a console port
z
Logging in to the router through the terminal emulation program and specifying the file
path in the terminal emulation program
Data Preparation
To configure XModem, you need the following data.
No. Data
1 Name of a specific file
2 Absolute path of the file
Configuration Procedures
No. Procedure
1 Getting a File Through XModem
8.7.2 Getting a File Through XModem
Do as follows on the router:
Run:
xmodem get filename
XModem is used to get the file.
To Next Page
Loading...
Need help?
General
