Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 2 Establishment of the Configuration Environment
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-11
[Quidway-aaa] quit
[Quidway] user-interface vty 0 4
[Quidway-ui-vty0-14] authentication-mode aaa
Step 3 Configure client login.
Run the Telnet on the PC, as shown in Figure 2-6.
Figure 2-6 Running the Telnet program on the PC
Click OK.
Enter the user name and password in the login window. After authentication, a command line
prompt such as
Quidway appears. Now enter the configuration environment in the user view.
----End
2.5.3 Example for Login Through the AUX Port
Networking Requirements
If you cannot configure the router by local login and there is no reachable route to other
routers, connect the serial port of the PC and the AUX port of the router through the Modem.
The detailed configuration environment is shown as Figure 2-7.
Figure 2-7 Establishing the remote configuration environment
Modem
Router
PC
COM
AUX
Modem
PSTN
To Next Page
Loading...
Need help?
General
