Huawei Quidway NetEngine 20 series

Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 8 FTP, TFTP and XModem
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-7
system-view
The system view is displayed.
Step 2 Run:
ftp server enable
The FTP server is started.
----End
8.3.3 Configuring the Basic ACL
Do as follows on the router that serves as the FTP server:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
acl acl-number
The ACL view is displayed.
Step 3 Run:
rule [ rule-id ] { deny | permit } [ source { | source-ip-address { source-wildcard |
0 } | any } | time-range time-name | vpn-instance vpn-instance-name ]
*
The ACL rule is configured.
----End
FTP supports only the basic ACL.
8.3.4 Configuring the Basic FTP ACL
Do as follows on the router that serves as the FTP server:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ftp acl acl-number
The basic FTP ACL is configured.
----End