Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 8 FTP, TFTP and XModem
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-3
z
The receiving program sends the acknowledgement character after the check passes. The
sending program then sends the next packet.
z
If the check fails, the receiving program sends the deny character and the sending
program retransmits the packet.
NE20/20E provides the function of XModem receiving program, which can be applied to the
AUX port and supports 128-byte packets and CRC. The function of XModem sending
program is automatically included in the HyperTerminal.
z
The XModem function is supported only by the AUX port.
z
XModem does not support simultaneous operations of multiple users.
8.2 Configuring the Router to be the FTP Server
8.2.1 Establishing the Configuration Task
Applicable Environment
Configure FTP to transfer files between the FTP client and the remote server.
When the router serves as the FTP server, for security, you can configure the router by ACL to
be accessed by only those clients that satisfy the matching conditions.
Pre-configuration Tasks
Before configuring FTP, complete the following tasks:
z
Powering on the router
z
Connecting the FTP client with the server
Data Preparation
To configure FTP, you need the following data.
No. Data
1 FTP username and password
2 The file directory authorized to the FTP user
3 The timeout time of the FTP server
Configuration Procedures
No. Procedure
1 Enabling the FTP Server
2 Configuring the Timeout Period
To Next Page
Loading...
Need help?
General
