5 User Management
Quidway NetEngine20/20E
Configuration Guide - Basic Configurations
5-12 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 05 (2010-01-30)
Action Command
Check the maximum number
of VTY user interfaces.
display user-interface maximum-vty
Check the physical attributes
and configurations of the user
interface.
display user-interface [ ui-type ui-number ] [ summary ]
5.3 Configuring User Management
5.3.1 Establishing the Configuration Task
Applicable Environment
This section describes how to configure the user priority and the authentication.
To access the network, remote users can log in to the router to access networks through Telnet
or establish a PPP connection with the router. This can be done if the router is configured with
the IP address of the MCU or that of the interface board. Remote users access the network by
establishing PPP connection with the router. To ensure network security and ease user
management, configure a username and the user password for the router.
Pre-configuration Tasks
Before configuring user management, complete the following tasks:
z
Powering on the router
z
Connecting the PC with the router properly
Data Preparation
To configure user management, you need the following data.
No. Data
1 Authentication mode
2 Username and password
3 User priority
Configuration Procedures
No. Procedure
1 Configuring Authentication Mode
2 Configuring the Authentication Password
To Next Page
Loading...
Need help?
General
