Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 9 Telnet and SSH
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9-7
9.2.2 Establishing a Telnet Connection
Do as follows on the logon router:
Step 1 Connect the PC with the router through Telnet and the terminal. For details, see Chapter 2,
"Configuration environment setup."
Step 2 Run:
telnet [ vpn-instance vpn-instance-name ] [-a source-ip-address] host-name
[ port-number ]
You can now log on to the router through Telnet and manage other routers.
Step 3 Run:
telnet ipv6 [-a source-ip-address] host-name [ -i interface-type interface-number ]
[ port-number ]
You can now log on to the router through Telnet and manage other routers.
Perform Step 2 to configure the network based on IPv4, and perform Step 3 to configure the
network based on IPv6.
----End
9.2.3 Scheduled Telnet Disconnection
Do as follows on the login router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface [ ui-type ] first-ui-number [ last-ui-number ]
The user interface view is displayed.
Step 3 Run:
idle-timeout minutes [ seconds ]
The scheduled Telnet disconnection is enabled.
----End
9.2.4 Checking the Configuration
Run the following commands to check the previous configuration.
Action Command
Check the connection status of the current
user-interface.
display users
Check the connection status of all user-interfaces.
display users all
To Next Page
Loading...
