Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 5 User Management
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-5
z
Confirm the user interface type and configure the login parameters of the user interface.
z
Classify the login user level and configure the authentication mode for the user.
z
Configure the terminal services.
The following shows only how to configure a user interface.
Pre-configuration Tasks
Before configuring a user interface, complete the following tasks:
z
Powering on the router
z
Connecting the PC with the router properly
Data Preparation
To configure a user-interface, you need the following data.
No. Data
1 Transmission rate (optional)
2 Flow control mode (optional)
3 Parity mode (optional)
4 Stop bits (optional)
5 Data bits (optional)
6 Terminal user timeout (optional)
7 One-screen length of the terminal screen (optional)
All the default values of the data are stored on the router and does not need additional configuration.
Configuration Procedures
No. Procedure
1 Transmitting Messages Between User Interfaces
2 Configuring Asynchronous Interface Attributes
3 Setting Terminal Attributes
4 Configuring the User Interface
5 Configuring Modem Attributes
6 Configuring an Auto-executed Command
7 Configuring the Redirection Function
8 Configuring the Call-in or Call-out Restrictions of the VTY User Interface
To Next Page
Loading...
