Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 9 Telnet and SSH
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9-27
[RouterB] user-interface vty 0 4
[RouterB-ui-vty0-4] authentication-mode password
[RouterB-ui-vty0-4] set authentication password simple 123456
[RouterB-ui-vty0-4] quit
Step 3 Log in to Router B from Router A through Telnet.
<RouterA> telnet 1.1.1.2
Trying 1.1.1.2 ...
Press CTRL+K to abort
Connected to 1.1.1.2 ...
***********************************************************
* All rights reserved (2000-2005) *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
* Notice: *
* This is a private communication system. *
* Unauthorized access or use may lead to prosecution. *
***********************************************************
Login authentication
Password:
Note: The max number of VTY users is 5, and the current number
of VTY users on line is 1.
<RouterB>
----End
Configuration Files
z
Configuration file of Router A (It is not mentioned here.)
z
Configuration file of Router B
#
sysname RouterB
#
interface GigabitEthernet1/0/0
ip address 1.1.1.2 255.255.255.0
#
user-interface vty 0 4
set authentication password simple 123456
#
return
9.8.2 Example for Connecting the STelnet Client to the SSH
Server
Networking Requirements
As shown in Figure 9-6, after the STelnet service is enabled on the SSH server, the STelnet
client can log in to the SSH server through the password or RSA authentication.
Configure two login clients:
To Next Page
Loading...
Need help?
General
