2 Establishment of the Configuration Environment
Quidway NetEngine20/20E
Configuration Guide - Basic Configurations
2-12 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 05 (2010-01-30)
Configuration Roadmap
1. Establishing the physical connection
2. Configuring Modem parameters
3. Configuring the AUX port to support the Modem dialup
Data Preparation
z
Type of terminals
z
Terminal communication parameters
z
Modem communication parameters
Configuration Procedure
Step 1 Establish the physical connection as shown in Figure 2-7.
Step 2 Configure the AUX port to support the Modem dialup.
<Quidway> system-view
[Quidway] aaa
[Quidway-local-aaa-server] local-user huawei password cipher test1
[Quidway-local-aaa-server] local-user huawei service-type terminal
[Quidway-local-aaa-server] local-user huawei level 3
[Quidway-local-aaa-server] quit
[Quidway] user-interface aux 0
[Quidway-ui-aux0] authentication-mode aaa
[Quidway-ui-aux0] modem both
Step 3 Configure Modem parameters.
# Run the PC emulation terminal, refer to Establishing the Configuration Environment by the
Console Port.
Press Enter on the PC emulation terminal/ terminal until a command line prompt of the
Modem such as
> appears.
Configure the Modem to meet the requirements of AUX communication.
For details, refer to Modem descriptions.
Step 4 Log in to the router.
Enter the user name and password in the remote terminal emulation program.
After authentication, a command line prompt such as
Quidway appears.
Enter the command to check the running status of the router or configure the router.
Enter "?" for help.
For detailed operations, refer to the following chapters.
----End
To Next Page
Loading...
Need help?
General
