Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 10 Router Maintenance
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10-5
z
Ensuring that the router can be logged in to
Data Preparation
None.
Configuration Procedures
No. Procedure
1 Specifying the Slave RPU
2 Restarting the Router
3 Performing the Master/Slave Switchover
10.3.2 Specifying the Slave RPU
NE20 contains only one RPU, so NE20 does not support this function.
Do as follows on the router to be configured.
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
slave default slot-number
The default slot number of the slave RPU is specified.
The slot number specified by this command is reserved for the slave RPU each time after the
router is restarted. The other slot number is for the master RPU.
Step 3 Run:
quit
The user view is displayed.
Step 4 Run:
save
The current configuration is saved.
----End
10.3.3 Restarting the Router
To Next Page
Loading...
Need help?
General
