Quidway S1700 Series Ethernet Switches
Web User Manual 3 System Management
Issue 01 (2011-11-17) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
12
Table 3-1 Parameters of “System > General” Information
Title Description
System Description Brief description of device type
System Up Time Length of time the management agent has been up.
System Name Name assigned to the switch system
System Location Specifies the system location.
System Contact The contact information of the administrator
System Jumbo Frame Enable or disable system jumbo frame. (default:disabled)
System EEE Enable or disable system EEE. (default:disabled)
1. Click System > General.
2. Specify the system name, location, and contact information for the system administrator,
enable or disable system jumbo frame and system EEE.
3. Click Apply.
----End
3.2 Setting the Switch’s IP Address
Use the System > IP page to configure VLAN and an IPv4 address for management access
over the network.
At default, the device obtains an address from DHCP server. If failed to obtain IP address, a
static address of 192.168.0.1 will be assigned.
To obtain a dynamic address through DHCP for the switch:
1. Click System > IP.
2. Select the VLAN through which the management station is attached, set the IP Address Mode
to “DHCP”.
3. Click Apply to save your changes.
4. Then click Restart DHCP to immediately request a new address.
To Next Page
Loading...
Need help?
General