Quidway S1700 Series Ethernet Switches
Web User Manual 4 Interface Configuration
Issue 01 (2011-11-17) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
27
Configuring by Port Range
Use the Interface > Port > General (Configure by Port Range) page to enable/disable
interfaces, set auto-negotiation and the interface capabilities to advertise, or manually fix the
speed, duplex mode, and flow control.
Figure 4-3 Configuring Connections by Port Range
1. Click Interface > Port > General. Select Configure by Port Range from the Action List.
Figure 4-3 is displayed.
2. Specify the Port Range and setup the configuration parameters.
3. Click Apply. It takes effect immediately.
View the port status by clicking Interface > Port > General and selecting Show Information
from the Action List.
----End
4.1.2 Configuring Local Port Mirroring
Use the Interface > Port > Mirror page to mirror traffic from any source port to a target port
for real-time analysis. You can then attach a logic analyzer or RMON probe to the target port
and study the traffic crossing the source port in a completely unobtrusive manner.
z
Traffic can be mirrored from one or more source ports to a destination port on the same
switch (local port mirroring as described in this section).
z
Target port speed should match or exceed source port speed, otherwise traffic may be
dropped from the target port.
To add a local mirror session:
1. Click Interface > Port > Mirror. Select Add from the Action List. Figure 4-4 is displayed.
To Next Page
Loading...
