Hytera PDC680 - Screens; Understanding the Home Screens; Understanding the LCD Icons

8
4. Battery
4.1 Viewing the Remaining Battery Power
1.
Tap .
2.
Tap
Battery
.
3.
Enable
Battery percentage
.
The percentage of the remaining battery power is shown in the status bar.
4.2 Enabling the Power Saving Mode
To enable the power saving mode, do either of the following:

Swipe down from the top to enter the control and notification center, and then enable
.

Tap , go to
Battery
>
Battery Saver
, and then do either of the following operations:

Tap
TURN ON NOW
.
The power saving mode is enabled immediately.

Enable
Turn off when fully charged
.
The power saving mode will be enabled according to the remaining battery power.
4.3 Setting the Work Type
1.
Tap .
2.
Go to
Battery
>
Work type
.
3.
Select
Standard
,
Phone
, or
Radio
.

Standard: The narrowband and broadband networks are enabled at the same time.

Phone: The broadband network is enabled, while the narrowband network is disabled.

Radio: The narrowband network is enabled, while the broadband network is disabled.
4.4 Viewing the Battery Health
1.
Tap .
2.
Go to
Battery
>
Battery status
.
You can view the battery version, health, temperature, and times of charge and discharge.