To Next Page

To Previous Page

Chapter 11. Command troubleshooting

This chapter describes problems you might experience with commands.

On Solaris 8 operating systems, checkprereq processes do not

complete

If a prerequisite check is executed for an agent on a UNIX or Linux endpoint,

either with the tacmd checkprereq command or the tacmd createnode command

with the -o EXECPREREQCHECK=Y command-line option, certain processes might

not complete. If you supply a Windows-syntax installation directory (for example,

C:\IBM\ITM) with either the -d | --directory flag or the group deployment

property (KDY.INSTALLDIR=C:\IBM\ITM), the execution of the prerequisite check

on the endpoint might hang some processes on UNIX or Linux operating systems.

However, if you observe this situation in your enviroment, you can end those

processes without causing additional problems. To avoid this issue, provide the

prerequisite check with the appropriate directory syntax for UNIX and Linux (for

example, /opt/IBM/ITM).

Situations deleted from the CLI are still listed on Tivoli Enterprise

Portal Situation editor

If you stop your hub Tivoli Enterprise Monitoring Server (TEMS) and then delete

situations using tacmd deletesit, the situations are deleted from the CLI, but are

still listed on the Tivoli Enterprise Portal (TEP) Situation editor. To avoid this issue,

delete situations from the CLI while the TEMS is running. As appropriate, the

situations do not display on the Situation editor.

The tacmd addBundles command returns an unexpected KUICAB010E

error message

Using the tacmd addBundles command results in an unexpected error message:

KUICAB010E: The addBundles command did not complete.

Refer to the following returned error: ERRORTEXT

The tacmd addBundles command is used to add one or more deployment bundles

to the local agent deployment depot. By default, this command also adds all

deployment bundles that are prerequisites of the deployment bundle being added,

if the prerequisite bundles do not already exist in the depot. The tacmd

addBundles command requires double the size of the bundle disk space free in the

depot (including the agent and all prerequisite bundles). The kdyjava.log file in the

system temp directory provides additional information about the problem.

tacmd removeBundles command returns unnexpected KUICRB010E

error message

Using the tacmd removeBundles command results in an unexpected error message:

KUICRB010E: The removeBundles command did not complete.

Refer to the following returned error: ERRORTEXT

IBM E027SLL-H - Tivoli Monitoring - PC User Manual

Questions and Answers: