You receive the message “Empty Data Set”
The Empty Data Set message is not an error. The message is displayed to convey
that no data was returned when it ran the report. The message is usually displayed
for one of three reasons:
v The report parameters have excluded all the data.
v You recently started using IBM Tivoli Monitoring for Energy Management and
have not put data into the Tivoli Data Warehouse.
v The computers you are monitoring do not have the correct level of firmware.
If you think you have received this message incorrectly, run the Exception Report
to find if there is another reason why no data is being returned.
254 IBM Tivoli Monitoring: Troubleshooting Guide
To Next Page
Loading...
Need help?
General
