This parameter is described in the “Timekeeping in VMWare Virtual Machines”
paper on the VMWare website: IBM Service Management Connect
(http://www.vmware.com/files/pdf/Timekeeping-In-VirtualMachines.pdf).
Measurement experience has shown that this setting can significantly improve the
tacmd command response time on VMWare ESX systems.
The addSystem command fails with error message KUICCR099E
The KUICCR099E error occurs when at least one incorrect parameter was specified.
When adding managed systems with the addSystem command, ensure that you
v Specify the correct product code.
v Specify a correct node that is online. You can run the listsSystems command to
verify that the node is online.
v Specify correct properties.
tacmd addSystem {-t|--type} TYPE
[{{-n|--node} MANAGED-OS} |
{{-d|--dir|--directory} NODEDIR}}} ]
[{-i|--imagePath} IMAGEPATH]
[{-p|--property|--properties} NAME=VALUE ...]
where:
-t|--type
Specifies the type of managed system to add to the monitoring system. You
can specify a managed system type name or its associated two-character
code. Use viewDepot to display a list of correct managed system types.
-n|--node
Specifies the node to start. A node is identified by the managed operating
system that it contains.
MANAGED-OS
Specifies a correct managed operating systems.
-d|--dir|--directory} NODEDIR
Specified the correct name of the directory that contains the node
components, including the OS agent. This syntax is only correct when the
node is on the local system.
-i|--imagePath
Specified the correct directory that contains agent installation images.
-p|--property|--properties
Specifies one or more NAME=VALUE pairs that identify configuration
properties of the new system and their values. Run the
describeSystemType command to determine correct values for the
properties.
The tacmd getdeploystatus command is not returning status return
codes
At this time, there is not a workaround for this issue.
212 IBM Tivoli Monitoring: Troubleshooting Guide
To Next Page
Loading...
Need help?
General
