2. Select the pdisk that you want to identify or put into Service Mode (for example,
pdisk3). The following display appears with details of the disk drive module that
you have just selected.
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SSA SERVICE AIDS 8238 │
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SET SERVICE MODE 82381 │
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SET SERVICE MODE 82382 │
│ │
│ pdisk3 44444444 -4-P 2 GB SSA F Physical Disk Drive │
│ │
│ Move cursor onto selection, then press Enter. │
│ │
│ + Set or Reset Identify. │
│ Select this option to set or reset the Identify indicator │
│ on the disk drive. │
│ > Set or Reset Service Mode. │
│ Select this option to set or reset Service Mode │
│ on the disk drive. │
│ │
│ │
│ │
│ │
│ F3=Cancel F1=Exit │
│ │
└──────────────────────────────────────────────────────────────────────────────────┘
Chapter 3. Error Code to FRU Index 3-69
To Next Page
Loading...
