The Set Address icon allows you to define addresses from which your computer can
receive RIPL code.
Notes:
1. Some applications may require that IP addresses contain leading zeroes for
numbers less than 100. For example, 129.132.4.20 may need to be entered as
123.132.004.020.
If any of the addresses is incomplete or contains a number other than 0 to 255, an
error message is displayed when you select the Save icon. To clear this error,
change the improper address and select Save again.
Note: You should save a copy of your changes in case you need to replace your
battery.
5-18 Service Guide
To Next Page
Loading...
