Surveillance Setup Menu
This option may be used to setup operating system surveillance.
à ð
OS Surveillance Setup Menu
1. Surveillance:
Currently Disabled
2. Surveillance Time Interval:
Currently 5
3. Surveillance Delay:
Currently 1
98. Return to Previous Menu
á
ñ
– Surveillance
May be set to Enabled or Disabled.
– Surveillance Time Interval:
May be set to any number from 2 to 255 minutes.
– Surveillance Delay:
May be set to any number from 0 to 255 minutes.
Refer to “Service Processor System Monitoring - Surveillance” on page B-28 for
more information about surveillance.
Reset Service Processor - Allows the user to reinitialize the Service Processor.
Reprogram Service Processor Flash EPROM - This is an automatic process.
An update diskette can be acquired from the RS/6000 Support page on the
Internet or from your service team. The Internet address is:
http://www.rs6.ibm.com/support/micro
The update files must be downloaded to a DOS-formatted diskette. You should
format the diskette just prior to receiving the download, to be sure it is clean.
Reformatting is worth the time and effort. When this process is selected, you are
prompted to place the diskette into the drive and to indicate to the system that
the diskette in available and the automatic process starts. If the system has other
needs, you are prompted. See “Service Processor Firmware Updates” on page
B-31 for additional information and update methods.
Appendix B. Service Processor Menus B-11
To Next Page
Loading...
Need help?
General