Chapter 6. Installing the Library 6-5
Removing the Library Control Blade
Figure 6-3. Library Control Blade removal
To remove the Library Control Blade installed in the library:
1. Loosen the two blue thumb screws ( in Figure 6-3) on the Library Control
Blade by turning them counterclockwise.
2. Place two fingers under the handle ( in Figure 6-3) and slowly pull the Library
Control Blade toward you while supporting it from underneath.
Removing the Cartridge Magazines
To unlock the cartridge magazines manually:
1. On the rear panel, locate the access hole for the cartridge magazine locking
release mechanism to the right of the power supply units ( in Figure 6-4).
a34z0060
1
2
1
2
1
To Next Page
Loading...
