9-22 TS3400 Tape Library Maintenance Information
6. Remove the four screws securing the drive docking card ( in Figure 9-21) to the
library frame, and remove the drive docking card.
Figure 9-21. Drive docking card
Replacement Procedure
1. Remove the packaging from the replacement drive docking card.
2. To replace the drive docking card, perform the steps to remove the drive docking
card in reverse order.
3. Run the Library Verify test in the Service Mode menu. See “Running Library
Verify Diagnostics” on page 7-5.
4. If requested, take the library online. See “Taking the Library Offline/Online” on
page 7-23.
5. Package the failed drive docking card in the same packaging that the new drive
docking card was shipped to you in, and return to IBM.
6. Go to “End of Call” on page 7-26.
2
a34z0021
2
1
To Next Page
Loading...
