Chapter 9. Check, Adjust, Remove, and Replace Procedures 9-31
Note: Use caution when removing the screws securing the door to the front of the
library frame and when opening the door. It is possible for the door and LCD
panel display to be detached from the frame when the top cover is removed,
damaging the LCD ribbon cable.
13. Remove the flat cable from the clamps on the rear of the library door
(Figure 9-33), and pull the flat cable ( in Figure 9-34) back through the hole in
the library door ( in Figure 9-34).
Figure 9-33. Flat cable clamps on rear of library door
Figure 9-34. LCD display card cable disconnected
14. On the sides of the library, remove the four screws securing the center pillar (
in Figure 9-35) of the library frame, and remove the pillar.
1
2
a34z0149
a34z0052
1 2
1
To Next Page
Loading...
