Chapter 8. Drive Maintenance Procedures 8-21
13. While the microcode load takes place the display shows:
The drive display shows the loading status messages at the bottom of the display.
14. When the microcode load completes, the initiator display shows:
The drive performs a soft power-on reset (restart the microcode).
15. Press F10 to exit the microcode load.
16. Press q to quit tapeutil.
Note: You must have administrator privileges to perform the following step.
17. Update the VPD data in the host pSeries (RS/6000) AIX by unconfiguring the
device (Example: rmdev -l rmt3). and reconfiguring the device (Example: mkdev
-l rmt3).
18. Press Ctrl+] to get a telnet> prompt, then type quit to stop the TELNET session.
19. Remove the CD-ROM from the CD drive.
Starting NT UTILITY (NTUTIL) from Windows NT or Windows
2000
For a complete update on device driver software, see the IBM SCSI Tape Drive,
Medium Changer, and 3592 Device Drivers: Installation and User’s Guide.
You may require assistance from the customer during this process.
Follow this procedure to start NTUTIL.
1. Click the Start icon.
2. Select Program, Accessories, Command Prompt.
On the next screen, the cursor will be at the right of the default prompt C:\>. Any
data that is read will be stored in that drive/directory and any data written will
try to originate from the same drive/directory. If you wish to read to or write or
write from a different drive/directory, enter cd newdir (where newdir is a fully
qualified, valid drive) and dir to change to the new directory.
3. Enter ntutil. The following main menu appears on the screen.
Prompting for Srce File for Operation on rmt3 located at 00-05-01-30
B00000
Please enter the following fields...
Enter Filename: /tmp/3592.fmr
F1=Help F2=Refresh F3=Cancel F4=List
F5=Reset F7=Commit F10=Exit
"Operation running, please standby"
Operation completed successfully!
To Next Page
Loading...
