Chapter 8. Drive Maintenance Procedures 8-25
The following screen is displayed when the verification test completes
successfully:
5. When the Tape Device Test menu is displayed, select Exit test menu 3.
Checking Channel Attachment – pSeries/RS6000 AIX
The devices must be fully installed and the host device driver must be configured and
available. See IBM SCSI Tape Drive, Medium Changer, and Library Device Drivers:
Installation and User’s Guide for information about installing and using the IBM tape
drive, medium changer, and library device drivers. Also, “Installation and
Configuration Instructions” in the above guide describes the smit and cfgmgr
commands.
Figure 8-2 shows an example of software and hardware paths that are used in the
following tests. The figure illustrates the unique initiator addresses for a
configuration with more than one initiator sharing a fibre channel.
AJCUHQV2 Tape Device Test Menu
Select one of the following:
1. Basic read/write test 2
2. Read/write reliability test
3. Exit test menu 3
Selection
_
F3=Exit
AJCUHQV3 Tape Problem Analysis
The verification test completed successfully.
Press Enter to continue.
To Next Page
Loading...
Need help?
General