Chapter 6. Installing the Library 6-13
Installing the Rails
Figure 6-14. Rail mounting in rack (front view)
Note: The left and right rails ( in Figure 6-14) are identified by “FL” and “FR”
markings ( in Figure 6-14) near the front edge of each rail, respectively.
To install the Rack Mount Kit rails:
1. Collapse the rail so that it fits neatly between front and rear vertical rail posts.
2. Insert the studs on the front of the sliding rail into the holes marked on the front
vertical post.
3. Insert centering screws in each of the vertical posts (two screws on each of the
front rails) and finger-tighten. The screws occupy the following rack locations (
in Figure 6-12):
• Bottom hole in the second 1U space
• Top hole in the fourth 1U space
4. From the rear of the library, extend the rail and insert the rail studs into the
marked holes in the rear vertical post.
a34z0034
1
2
1
2
2
To Next Page
Loading...
