EasyManua.ls Logo

IBM System Storage TS3400 Tape Library - Page 182

IBM System Storage TS3400 Tape Library
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-28 TS3400 Tape Library Maintenance Information
4. At the Enter Selection: prompt, select the Open a Device option, and press
Enter.
5. At the Enter the device special file name: prompt, type /dev/rmt1 (or your actual
device).
6. At the Select mode (1=Read/Write, 2=Read Only, 3=Write Only, 4=Append):
prompt, type 1 to receive the Opening device… prompt.
7. At the Hit any key to continue… prompt, press Enter.
8. At the Enter Selection for /dev/rmt1: prompt, select the Inquiry option to receive
the Issuing inquiry… and the following data:
9. At the Hit any key to continue… prompt, press Enter.
10. At the Enter Selection for /dev/rmt1: prompt, select the Close a Device option.
The system response is Device closed…
Read and Write Tests
Load a CE scratch tape in the 3592 before you start this test.
Important: This test overwrites any data or tape label on the tape.
1. If the response from the previous test is Hit any key to continue…, press Enter.
Otherwise, type tapeutil to restart.
Note: Your tapeutil menus may vary from the examples, depending on the level
of the Atape.driver installed in your system. The following examples use
Atape.driver at 2.5.1.0.
General Commands:
1. Open a Device 5. Inquiry 9. Log Sense Page
2. Close a Device 6. Test Unit Ready 10. Mode Sense Page
Inquiry Data, Length 127
0 1 2 3 4 5 6 7 8 9 A B C D E F 0123456789ABCDEF
0000 - 0180 0202 3300 0038 4942 4D20 2020 2020 ..3..8IBM
0010 - 3033 3539 3045 3031 3033 3539 3042 3131 03592B1103592B11
0020 - 3344 3201 4353 3030 3030 3030 3030 3031 3D2.CS0000000001
0030 - 3632 2041 C000 0180 04D0 6101 82D0 6101 62 A.....Pa..Pa.
0040 - 80D0 6101 .Pa.. a..Pa..Pa.
0050 - 02D0 Example 0000 .Pa..Pa.........
0060 - 0000 0000 ................
0070 - 0000 0000 0000 0000 0000 0000 0000 00 ...............
General Commands:
1. Open a Device 5. Inquiry 9. Log Sense Page
2. Close a Device 6. Test Unit Ready 10. Mode Sense Page
General Commands:
1. Open a Device 5. Inquiry 9. Log Sense Page
2. Close a Device 6. Test Unit Ready 10. Mode Sense Page

Table of Contents

Related product manuals